| ESG-NC700 |
 |
| Table Size |
305x712mm |
| Longitudinal movement speed |
0.5~25M/min |
| CONTROL PANEL |
|
 |
|
| GRINDING PROCEDURES |
|
 |
|
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| MORE.... |
|
Specifications: |
MODEL |
NC700 |
|
DESCRIPTIONS |
| Table Size |
|
305x712mm |
| Longitudinal Movement Speed |
0.5~25M/min |
| Cross Transverse Travel |
Min. Setting Unit |
0.001mm |
| MPG |
Handwheel graduation x 1, 0.001mm x 10, 0.01mm x 100, 0.1mm |
| Rapid Speed |
1000mm/min |
| Wheelfeed Vertical Infeed |
Min. Setting Unit |
0.001mm |
| MPG |
Handwheel graduation0.001mm x 1, 0.001mm x 10, 0.001mm x 100 |
| Rapid Speed |
750mm/min |
| Spindle Drive |
Power Rating |
Standard 3.7KW(5HP) Optional 5.55KW(7 1/2HP)., 7.4KW(10HP) |
| Speed |
50HZ,1450 R.P.M.;60HZ,1750 R.P.M. |
| Standard grinding Wheel |
Diameter |
ø 355mm |
| Width |
50mm |
| Bore |
ø 127mm |
| Hydraulic Motor |
|
3.0HP |
| Floor Space |
|
2950x2150x2150mm |
| NOTE: The manufacturer reserves the right to modify the design, specifications, mechanisms, etc., to improve the performances of the machine without notice. All the specifications shown above are just for reference. |
|
| General Features: |
| 1.STRUCTURE: |
Remote manual pulse generator for vertical & crossfeed |
C3 class vertical & crossfeed ballscrew |
Spindle frequency inverter |
Verical & crossfeed servo motor control system, man-manchine interface w/10.4" color tft display, plc w/nc mode control |
Longitudinal movement servo hydraulic control system |
Unique longitudinal hydraulic circuitry system is available for slow movement from either direction ( suitable for big downfeed at slow table movement ) |
| 2.CONTROL SYSTEM: |
|
High industrial class plc control system w/nc program mode |
| 3.SOFTWARE SYSTEM: |
Man-machone conversational diagram data input working system |
Easy to learn and operate |
Learn it in 4 hours grinding set in 10 minutes for new workpiece |
| 4.STANDARD FUNCTION: |
|
Surface grinding (cross step feed constant feed, and 3 steps downed) |
Plunge grinding (2 steps downed) |
Groove bottom surface grinding (cross step feed & constant feed, 2 steps downed) |
|
Multi-plunge grinding system suitable for un-equidepth, concave, convex, and trapezoidal plunge grinding (only by cbn forming wheel, forming device, or on-table wheel derssing attachment) |
| 5.DURING GRINDING: |
The infeed amount is adjustable any time |
The grinding wheel could be forced rise up |
Can be stopped and proceeded for workpiece checking |
Can be forced for wheel dressing or dressing setting change |
| 6.OPTIONAL ACCESSORIES: |
Overhead wheel auto dressing & auto compensation system |
On-table wheel auto dressing & auto compensation system |
The fourth axis scale plate and special clamper for workpiece |
|
|
|
